1-Wire bus for temperature logging
Posted <2017-01-25 Wed 22:08> by Aaron S. Jackson.
I've been wanting to set up a bunch of temperature sensors around my house. Tonight I installed my first one. Here is the first splice into the bus:
And here is a close up of the temperature sensor module. Only this one should require a resistor, which is why I put it on some perfboard.
The sensor is a DS18B20+ three pin temperature sensor which operates on a 1wire bus. The resistor is a pull up resistor required for two-way signalling on a single wire. The following graph should update in real-time, unless I desert this project :)
Related posts:
Wanting to leave a comment?
Comments and feedback are welcome by email (aaron@nospam-aaronsplace.co.uk).